LM 363 Contact-Grease

DESCRIPTION LM 363 Contact Grease is a grease-type, fully synthetic contact treatment preparation compatible with plastics and free of silicones. The special additives, synthetic oil and consistency modifiers in this product ensure that it can be used over a wide range of temperatures. The product shows no signs of chemical decomposition or resinifying even after long periods of use and is characterised by very good low-temperature properties.-

PROPERTIES - very compatible with plastics
- stable to ageing, liquifying and oxidation
- reduces contact resistance
- suppresses arcing and wear
- penetrates layers of oxides and sulphides
- good mechanical lubrication properties
- high corrosion protection

TECHNICAL
DATA Colour : light brown, natural colours
Basis : synthetic oil
Consistency modifiers : organic thickeners
Base oil viscosity : 45 mm2/s DIN 51 526
Flow pressure at -40°C : < 300 hPa DIN 51 805
Drop point : > 250 °C
NLGI number : 2
Corrosion protection
behaviour (Emcor test) : 0/1
Water resistance : fully resistant
3 hl/90°C
Copper corrosion : 0 DIN 51 811
Operating temperature : -40 °C to +120 °C
Specific electrical
resistance : 1.6 · 109 Ohm · cm

APPLICATION LM 363 Contact Grease is mainly suitable for the maintenance and protection of all types of contacts in weak current engineering. This applies both to predominantly dormant contacts (such as plug connections and compensating controllers) and to moving contacts (such as switches, sliders, relays and wire-wound potentiometers etc.).

INSTRUCTIONS Before treating with LM 363 Contact Grease, the contact surfaces must be clean and free from residues such as lubricants, dirt and moisture. Apply the product as a thin, uniform layer.

Before using the product, check for compatibility plastics sensitive to stress-cracking.

AVAILABLE
PACK SIZE LM 363 Contact Grease 25 kg hobbock Part no. 3165